How to Check Water Pump Status Remotely Without Site Visits

Out in the field, “Is the pump running?” sounds like a tiny question… until you’ve got 30 pumps spread across farms, canals, or wellheads. Then it turns into daily windshield time, fuel, and missed failures.

We recently helped a customer mount a Bluetooth beacon on water pump-type machines and use vibration to infer operating status. Simple logic. Big impact. When vibration is detected, the machine is running. When there’s no vibration, it’s stopped or possibly stuck. And the best part: no one has to drive around just to check. They open a phone or laptop dashboard instead.

Simple Concept: Detect Pump Running Status Using Vibration

Use a 블루투스 비콘 with a built-in 3D accelerometer to broadcast “movement present” vs “no movement,” then let a 태양광 블루투스 게이트웨이 collect that data and push it to the cloud. From there, it’s alerts and dashboards. Clean and practical.

Remote Water Pump Monitoring System Architecture (Off-Grid Ready)

How Vibration-Based Pump Monitoring Works in the Field

1. Where to Mount a Vibration Sensor on a Water Pump
   Usually, that’s the motor housing or a rigid bracket that vibrates when the pump runs. Not the loose guard that rattles in the wind.
2. Mount the solar gateway nearby with a decent sky view.
   The Lansitec NB-IoT/LTE-M Solar Bluetooth Gateway is built for exactly this kind of outdoor, no-power location. It supports iBeacon, Eddystone, and custom Bluetooth protocols, and it’s in an IP66 enclosure. Power-wise, it pairs a 3 W solar panel with a 5300 mAh Li-ion rechargeable battery.
3. Turn vibration into a status timeline.
   At the platform level, you typically implement a tiny state machine:
   • If “movement” frames are seen in the last 엑스 minutes, set Running.
   • If nothing is seen for Y minutes, set Stopped.
   • If it should be running (schedule) but is stopped, raise 경보.

That’s it. No DSP thesis required.

Why Vibration Is a Reliable Signal for Pump Running Detection

In industrial monitoring, accelerometers are a standard tool for measuring vibration signatures and detecting operating behavior. We’re simply using a lightweight version of that concept for run-status, not full predictive maintenance.

Real-World Deployment Tips for Remote Pump Monitoring

• Pick the right beacon for the job. If you want vibration or motion, use a tag/beacon designed to report movement data. The 아이3 tag’s built-in 3D accelerometer triggers movement-based advertising and supports multiple frames, so you can broadcast both ID and motion state.
• Tune intervals for “fast enough” alerts. The gateway supports adjustable reporting intervals, and its battery life depends on how often it scans and reports. Lansitec even publishes an example operating point: 1 month at 10 s 블루투스 수신 duration and 60 s report interval (useful as a sanity check when you’re configuring).
• Avoid false “Stopped” due to RF shadows. Metal frames and engine blocks can block BLE. If a pump is inside a shed or behind steel, move the gateway a bit higher or change the antenna placement.